PredefinedQuantity Enumeration

Enumeration of predefined quantities.

Definition

Namespace: DHI.Mike1D.Generic
Assembly: DHI.Mike1D.Generic (in DHI.Mike1D.Generic.dll) Version: 24.0.0.0 (11.1.1.1111)
C#
public enum PredefinedQuantity

Remarks

Remember to add an entry to the PredefinedQuantityTable whenever a new PredefinedQuantity is created.

Members

WaterLevel0 Level of water, from a fixed zero level.
WaterLevelChange1 Level of water, from a fixed zero level.
WaterLevelCorrection2 Correction of water level. Used in Data Assimilation context.
WaterDepth3 Depth of water, from lowest bottom point to surface.
WaterVolume4 Volume of water
WaterVolumeAboveGround5 Volume of water in nodes above ground
WaterFlowRateAboveGround6 Water flow rate to node volume above ground
WaterVolumeRetainedInMaxInflow7 Volume of water retained in a reservoir due to a maximum inflow restriction
WaterVolumeM118 Volume of water, as calculated by M11
WaterVolumeChange9 Change of volume of water
Undefined-1 
MassError10 Mass Error
MassErrorM11Comp11 Mass Error - M11 version
MassErrorAccumulated12 Mass Error accumulated
MassErrorAbsAccumulated13 Mass Error accumulated
MassErrorChecksum14 Mass Error check sum
MassErrorAccumulatedChecksum15 Mass Error check sum
MassBalanceCorrection16 Mass balance correction
FlowArea17 Flow area
FlowAreaTsMean18 Flow area, mean value over last time step
FlowAreaInStructure19 Flow area in structure
FloodedArea20 Flooded area, surface area
GateLevel21 Gate level
Discharge22 Discharge
DischargeCorrection23 Correction of discharge. Used in Data Assimilation contexts
DischargePerLength24 Discharge per length
DischargePerArea25 Discharge per area
DischargeInStructure26 Discharge in structure
DischargeFromSurface27 Discharge from catchments. Maximum inflow can be applied so actual inflow may differ (used on nodes, limited by geometry of node cover)
DischargeOutflow28 Discharge Outflow through open boundaries, in m^3/s. Inflow is negative.
DischargeStepAveraged29 Discharge Step Accumulated
LateralSources30 Discharge in/out of network, in m^3/s
LateralInflow31 Discharge into network, in m^3/s
LateralOutflow32 Discharge into network, in m^3/s
LateralOutflowReduction33 Discharge into network, in m^3/s
TimestepInflow34 Discharge, inflow to model, in m^3
TimestepOutflow35 Discharge, outflow from model, in m^3
TotalInflow36 Discharge, inflow to model, total from start of simulation
TotalOutflow37 Discharge, outflow from model, total from start of simulation
NodeInfiltration38 Discharge that is multiplied by the maximum node surface area below current water level (used for MU node infiltration)
DischargeHPoints39 Discharge on H points
FlowVelocity40 Flow velocity
FlowVelocityInStructure41 Flow velocity in structure
WindVelocity42 Wind velocity
WindDirection43 Wind direction
FlowWidth44 Storage width/flow width
FlowWidthTsMean45 Storage width/flow width, mean value over last time step
Time46 
TimeStep47 
NumberOfTriesForTimeStep48 
TotalRunOff49 Total Runoff from RainfallRunoff model
HydraulicRadius50 Hydraulic radius
ManningResistanceNumber51 Resistance
ChezyResistanceNumber52 Resistance
BedLevel53 Bed shear stress
BedShearStress54 Bed shear stress
CourantNumber55 CourantNumber number
Froude56 Froude number
WaterLevelSlope57 Water Level Slope
EnergyLevelSlope58 Energy Level Slope
EnergyLevel59 Energy Level
Conveyance60 Energy Level
NetRainfall61 Net rainfall
CatchmentDischarge62 Catchment Discharge
TotalLoad63 Total Load
WeirDischarge64 Discharge through a weir
PumpDischarge65 Discharge through a pump
Obsolete
PumpIsActive66 Pump is on
OverlandFlow67 Overland Flow Routed From Second Reservoir (NAM)
InterFlow68 Inter Flow Routed From Second Reservoir (NAM)
TotalBaseFlow69 Total Base Flow (NAM) - BaseFlow and LowerBaseFlow
BaseFlow70 Base Flow (NAM)
LowerBaseFlow71 Lower Base Flow (NAM)
InterFlowAndBaseFlow72 Inter Flow And Base Flow (NAM)
OverlandAndInterflow73 Overland and inter Flow Routed From Second Reservoir (NAM)
ActualRainfall74 Actual Rainfall
ActualEvaporation75 Actual Evaporation
RootZoneStorage76 Lower Zone Storage (NAM)
SurfaceStorage77 Surface Storage (NAM)
GroundWaterDepth78 Ground Water Depth (NAM)
InfiltrationToGroundWater79 Infiltration To Ground Water (NAM)
InfiltrationFlow80 Infiltration To Ground Water (NAM)
TotalInfiltration81 Total Infiltration
OverlandFlowFirstReservoir82 Overland Flow Routed From First Reservoir (NAM)
InterFlowFirstReservoir83 Inter Flow Routed From First Reservoir (NAM)
CapillaryFlux84 Capillary Flux (NAM)
OverlandFirstReservoirStorage85 Overland Flow First Reservoir Storage (NAM)
OverlandSecondReservoirStorage86 Overland Flow Second Reservoir Storage (NAM)
IrrigationSupply87 Irrigation Supply (NAM)
SnowStorage88 Snow Cover (NAM)
Temperature89 Temperature
ZoneTemperature90 Zone Temperature (NAM)
ZoneRainfall91 Zone Rainfall (NAM)
ZoneWaterRetention92 Zone Water Retention (NAM)
ZoneMeltingCoeff93 Zone Snow Storage (NAM)
ZoneSnowAreaCoverage94 Zone Snow Area Coverage (NAM)
ZoneMeltingWater95 Zone Melting Water (NAM)
ValveOpening96 Valve opening
CrestLevel97 Creste level
Force98 Force, e.g. coming from wind shear stress
GroundWaterLeakage99 Ground water leakage. Per second, multiplied on (wet perimenter)*(water depth)*(dx) on h-grid points
DamBreakBreachLevel100 Dam break breach level [m]
DamBreakBreachWidth101 Dam break breach width [m]
DamBreakBreachSlope102 Dam break breach slope
DamBreakPipeTopLevel103 Dam break pipe bottom level level [m]
InfiltrationToGroundWaterMinusCapillaryFlux104 NAM catchment recharge minus capillary flux
ControlStrategyId105 ID of a control strategy applied to a controlled item (a clas that implements Generic.IControllable)
Concentration106 Concentration of AD component
CO1107 CO1 coefficient on HDGridPoint. Used for M21 couplings
CO2108 CO2 coefficient on HDGridPoint. Used for M21 couplings
CO3109 CO2 coefficient on HDGridPoint. Used for M21 couplings
CO4110 CO2 coefficient on HDGridPoint. Used for M21 couplings
WaterSpillDischarge111 Water spill rate from spilling nodes
DisplacementFraction112 Displacement fraction from displaceable cover.
DamBreakBreachFlow113 Dam break breach flow
DamBreakCrestFlow114 Dam break crest flow
WaterSpillVolume115 Water spill volume from spilling nodes
NodeSources116 Discharge in/out of network, in m^3/s
NodeInflow117 Discharge into network, in m^3/s
NodeOutflow118 Discharge into network, in m^3/s
NodeInflowVolume119 Discharge volume into network, in m^3
NodeOutflowVolume120 Discharge volume out of network, in m^3
WaterSurcharge121 Water surcharge from nodes
FullReachDischarge122 Full reach discharge
SurfacePreciEvapoTranspiration123 Discharge per area through surface interface
ControlVariables124 All control module variables.
DischargeLTSContinuous125 LTS continuous discharge including dry weather flow between the jobs.
SourcesInflow126 Sources inflow. TODO: This is used only by SummedQuantityItem. Consider replacing NodeSourcesInflow and LateralSourcesInflow by just SourcesInflow.
DischargeVolume127 Volume of flow over time
TotalRunOffVolume128 Volume of flow over time
StructureCriticalFlowMode129 Flag indicating if the flow in the structure is critical.
StructureHeadLoss130 Head loss calculated over structure.
StructureHeadLossMode131 Flag indicating if head loss mode is active for structures.
DischargeEnergyEquation132 Discharge calculated in structure after solving energy equation.
ResidualEnergyEquation133 Residual of energy equation.
ResidualEnergyEquationComposite134 Residual of composite structure energy equation.
ControlSensors135 Control Module sensors.

Extension Methods

IsOneOf Returns true if enumeration is one of the listed ones.
(Defined by GenericExtensions)
Quantity Get quantity for PredefinedQuantity, predef
(Defined by GenericExtensions)
Quantity Get quantity for PredefinedQuantity, predef, adding description to Description.
(Defined by GenericExtensions)

See Also