IPESEData Interface |
Namespace: DHI.Mike1D.Mike1DDataAccess.PumpEmergencyStorageEstimator
The IPESEData type exposes the following members.
Name | Description | |
---|---|---|
![]() | AlarmLevels | Node Id to alarm level dictionary |
![]() | AlarmsId | Alarms Id |
![]() | AlarmTimes | Node Id to time when alarm level is reached |
![]() | CheckOnlyWetWellCriticalLevel |
Alarm level check is done only at the wet well node for the main pump station
|
![]() | Freeboard |
Freeboard, which is defined globally.
An alarm level for a node is determined as ground level minus the freeboard.
|
![]() | PESEId | Pump Emergency Storage Estimator Id |
![]() | PumpedVolumes | Pump Id to pumped volume from pump stop time to alarm time |
![]() | PumpSection |
List of pump section Ids.
The first Id corresponds to the main pump station.
|
![]() | PumpSectionId | Pump section Id |
![]() | PumpStop |
Flag specifying that all pumps except for the main pump need to be stopped during RunNumber=2
|
![]() | PumpStopDelay | Pumps are stopped with delay |
![]() | PumpStopTime | Time to stop pumps |
![]() | RunMode | Run mode |
![]() | RunNumber | Run number |
![]() | ScenarioId | Scenario Id |
![]() | SimulationId | Simulation Id |