IReach Properties

User's descriptive information related to the link

Specifies where the reach is connected at its end point (high chainage). Must be null if not connected.

List of gridpoints within reach, in order from start to end of reach.

True if the reach should always be pressurized (MU special reach with slope=0 and "weir" at transition to normal reach.)

Regulate reach with a discharge structure on first q-grid point. This is used for MU setups to limit Q to a QMax(H) og QMax(dH). QMax is set by a control in the control module

The XYZ LocationSpan contains the reach ID, start and end chainages and digipoints in one structure.

The maximal allowed distance between two points of the same type?

Restrict flow in the first q-grid point to be positive only. Default is false

Reverse the positive flow direction of the reach. Default is false

Specifies where the reach is connected at its start point (low chainage). Must be null if not connected.

Id for the cross section topologi that is to be used for the Link / Branch If TopoID is not used, set to empty string (null will be handled as the empty string).