| AutoGenerated | Flag specifying that the node was autogenerated. |
| BottomLevel |
Bottom level
For a junction node (node without volume (in a river setup)), this is set to the smallest bottomlevel of the surrounding reaches. |
| ExternalCoupledArea |
When coupled to an external water level, the effect of changing the water level in the
network model also affects the external water level. By specifying the external coupled area,
the actual water level boundary is modified to take the change in this
external coupled area into account.
It effectively has a smoothing effect on a coupling. The smaller coupled area, the more smoothing effect is applied. Setting the coupled area to 0 disables the procedure. |
| GroundLevel |
Ground level
For a junction node (node without volume (in a river setup)), this is not set, having value of MaxValue. |
| HasVolume |
Boolean specifying whether the enginenode has a volume.
Must be overwritten for enginenodes with a volume |
| HeadLossCalculator | Head loss calculator |
| ID | Node ID string. (Not associated with the reach ID's) |
| InfiltrationCalculator | Infiltration calculator |
| InternalNode | Returns true if the node is internal, i.e., not a boundary node. |
| Location |
The Location of the node. A node can be placed at more than one
location. This only handles one location. Used for searching for
initial conditions.
|
| MaxInflowFromSurface |
Maximum inflow from the surface, i.e. rainfall runoff type inflows.
This is only relevant for sewer type nodes, where the inflow is limited by a surface opening like a sewer grate. |
| NodeMaxInflowReservoir | Node max inflow reservoir |
| OpenBoundarySubType | Sub type of open boundary. |
| OpenBoundaryType | Type of open boundary. Check if node is an open boundary using InternalNode before accessing this property. |
| OpenSourceBoundary | Get the IOpenSourceBoundary for the node. Null when node is an internal node (not an open boundary node) |
| PressureReachNodeType | This nodes relation to pressurized sections of the network |
| PressureReachTailCrestLevel |
Minimum water level in the outflow from pressurized sections, and hence also minimum water level in the pressurized section
Only applicable when PressureReachNodeType is Tail. |
| ShadowNode | Returns true if the node is a shadow node, i.e. only representing a node from another domain (MPI) |
| XCoordinate | X coordinate of node |
| YCoordinate | Y coordinate of node |