| STActiveLayerData |
Active layer Parameters, the thickness of the active layer.
For active-layer-only models, this is the thickness were transport starts being scaled down. Set to zero to disable the scaling down. |
| STActiveLayerDataInterpolatable | Class that handles interpolation between active layer data |
| STAdditionalOutput |
Sediment outputs. This class has two purposes.
1) It is a helper class that helps creates quantities for result specification.
This is done by setting a flag and calling one of the 2) It will enable calculators inside the engine. If the flag is not set, the quantity will not be available for output. This is the case for the quantities: |
| STBaseComponent | Parameters for a ST component |
| STCohesiveComponent | Parameters for an ST component, including initial concentration and type |
| STCohesiveData | Sediment transport data |
| STComponentQuantities | Providing methods for creating quantities. |
| STData | Sediment transport data |
| STExtensions | Helper methods for ST data |
| STNonCohesiveComponent | Parameters for a ST sand component (non-cohesive) |
| STNonCohesiveData | Sediment transport data |
| STNonCohesiveModel | Global model parameters for non-cohesive sediment transport |
| STRemovalStructure | Class for ST Removal weirs |
| STSmartJaeggi | Parameters for the Adjustable Smart-Jaeggi transport model |
| BedLayerLayout | Layout of bed layer |
| MorphologicalUpdaterType | Type of morphological update |
| NonCohesiveSTBedSuspModel | Model type for non-cohesive bed load and suspended load |
| STActiveLayerDepthType | Type of depth definition for active layer |
| STFallVelocityType | Type of fall velocity used |
| STResistanceType | Sediment resistance type for MU |
| STSkinFrictionType | Skin friction type |
| STWeirFormulation | Removal weir methods |