DamBreakBase Fields

List of quantities that are accepted

Breach level, breach width, and breach slope are stored as components (in that order) in the StructureSourceBoundary.

Flag indicating if breach is open

If the structure is being controlled, then _controlStategyId contains the ID of the active control strategy

Level of dam (before breach)

Width of dam (before breach)

Downstream water level, as set by SetWaterLevels(Double, Double) Unit: [m]

The derivative of flow through the structure with downstream water level. The flow is calculated in the derived classes when the SetWaterLevels method is called. Unit: [m2/sec]

The derivative of flow through the structure with upstream water level. The flow is calculated in the derived classes when the SetWaterLevels method is called. Unit: [m2/sec]

Specifies how the dam break failure evolves

Type of failure trigger

Flow area through structure. Used by most (but not all) structures.

FlowDir is used to determine which parameters to use for the flow calculations. Derived by the SetWaterLevels(Double, Double).

Identification name of the structure

If _implicit == false, then the derivatives are always zero. Default value: true.

Location in the network

List of quantities that are offered

Flow through the structure. The flow is calculated in the derived classes when the SetWaterLevels method is called. Unit: [m3/sec]

The directory of the text output file is taken from this file path. It is set from the boundary data connection during Initialize().

Diagnostics are written into this Diagnostics during calculations. Set during Initialize(IDiagnostics)

Start time of simulation

Time N

Time N+1 = current time

Time that state results was written last time

Identification used to find referenced cross sections

Upstream water level, as set by SetWaterLevels(Double, Double) Unit: [m]

Writer, for writing state results