EngineExtensions Methods |
The EngineExtensions type exposes the following members.
| Name | Description | |
|---|---|---|
| Digipoints(EngineReach) |
Get the digipoints of the reach
| |
| Digipoints(EngineReach, Int32) |
Get the ith digipoint of the reach
| |
| DirectionUnitVector |
Calculates the direction vector of the reach at the given gridpoint,
as the average from the last to the next gridpoint.
| |
| FindReachWithStructure |
For a given structure, find the reach where it is located. Or null if it is not found.
| |
| FlowIntoNode |
Evalueate whether flow is into or out of the node.
When discharge is very small, water level slope is also taken into account. | |
| GetPorosity |
Get surface area of geometry at provided level, by interpolation
| |
| GetProxy(IModule) | ||
| GetProxy(IModule, EngineNode) | ||
| GetProxy(IModule, EngineReach) | ||
| GetProxy(IModule, EngineReach, Int32) | ||
| GetProxyReachGeneric | ||
| GetSurfaceArea |
Get surface area of geometry at provided level, by interpolation
| |
| GetSurfaceAreaCone |
Get surface area of geometry at provided level, by interpolation of cone/pyramid geometry
| |
| GetValueOrDefaultT |
Get engine data for the specified node, or returns null if node has no data
| |
| GetVolume |
Get volume of geometry at provided level
| |
| GetVolumeCone |
Get volume of geometry at provided level, by interpolation of cone/pyramid geometry
| |
| IsAutoCreated |
If node is automatically created. This happens when reach start/end connections are based on locations.
| |
| IsHDNode(EngineNet, EngineNode) |
Returns true if the engine node is an HD node
| |
| IsHDNode(EngineNet, Int32) |
Returns true if the engine node at index i is an HD node
| |
| IsHdReach |
Returns true if the engine reach is a HD reach
| |
| IsPressureNode |
Returns true if the engine node is in a pressurized section
| |
| IsRoutingReach |
Returns true if the engine reach is a routing reach
| |
| IsSpillingNode |
If node is spilling node, i.e. is a volume node, and has a cover that supports spilling
| |
| IsStructureOutlet |
Returns true if the engine node is a structure outlet
|