IReachLocationValueT Interface |
A value on a reach. If on a span, then both start and end chainage is set,
if on a location only the start chainage is set.
Namespace: DHI.Mike1D.Generic
Assembly: DHI.Mike1D.Generic (in DHI.Mike1D.Generic.dll) Version: 19.0.0.0 (11.1.1.1111)
SyntaxType Parameters
- T
[Missing <typeparam name="T"/> documentation for "T:DHI.Mike1D.Generic.IReachLocationValue`1"]
The IReachLocationValueT type exposes the following members.
Properties| Name | Description | |
|---|---|---|
 | DirectionPositive |
When two values are defined at the same point, this
specifies if the value is valid from the positive side
or from the negative side. When ordered, values from
the negative side goes before values from the positive side.
Only used if IsSpan is false, and there are two values at the same chainage point. It does not make a difference if there is only one value at the chainage point. Default value is false. |
| EndChainage |
End chainage of value. Only used if IsSpan is set.
|
| IsSpan |
Bool indicating if value is on a location or on a span.
|
| StartChainage |
Start chainage of value
|
| Value |
Value
|
See Also