DischargeStructure Properties

Discharge for a single structure.

Maximum limit on discharge controllable from outside. Only used if _useControlledMaxDischarge == true

Minimum limit on discharge controllable from outside. Only used if _useControlledMinDischarge == true

Calculated Discharge derivative with DownStreamWaterLevel. Downstream is relative to the direction of chainage. The value is calculated by SetWaterLevels. Unit: [m^2/s]

Calculated Discharge derivative with UpStreamWaterLevel. Upstream is relative to the direction of chainage. The value is calculated by SetWaterLevels. Unit: [m^2/s]

Calculated Discharge. The value is calculated by SetWaterLevels. Unit: [m^3/s]

Downstream water level.Downstream refers to the direction of chainage. The water level is set by use of SetWaterLevels Unit: [m]

Property used by (de)serializer, when it can not find proper target for a data field. Support of forward compatible data contracts.

Flow area through structure. Used by most (but not all) structures.

The discharge (and discharge derivatives) are scaled by the flow factor.

Structure ID

Used to get a consistent description of the structure. The ID comes in user units. Used e.g. when reporting errors, warnings and hints.

Flag to control if the structure is implicit or explicit. If the structure is explicit (Implicit == false) then the derivatives of the dicharge are always zero. Default value: true

Initial value of the discharge. Default: 0

Invert level down stream

Invert level up stream

Length of the structure. Unit: [m] Default value: 0m

Location property.

Maximum discharge. The discharge (absolute value) can not be raised above this level. Default: double.MaxValue

The maximum allowed rate of change of the discharge level. Default: double.MaxValue

Multiplicator or "number of structures" of this type. Used for modelling more structures at the same location with the same geometry in one go. Unit: [] Default: 1

The getter is used to get a list of errors.

Bank side that side-structure is located on

If side structure contains reservoir, and has the Coordinate set, this is not used (and should be set to Undefined).

Reservoir at end of side structure. Null if not side structure, or no reservoir is defined

Type of structure

String used to identified cross sections

Structure type, unique for each structure.

Upstream water level. Upstream refers to the direction of chainage. The water level is set by use of SetWaterLevels Unit: [m]

Use the controllable maximum discharge

Automatically set when controlling maximum discharge

Use the controllable minimum discharge

Automatically set when controlling minimum discharge

Use the controllable maximum discharge level