ICatchmentConnection Interface |
Interface for information on where a specific catchment
is connected in the network, and the area of the catchment
that goes into that part of the network.
The connection in the network is here defined by a ReachId
and and up- and down-stream chainage. If the two chainages are
the same, the connection is a point connection, otherwise
it is a span (distributed) connection.
Namespace: DHI.Mike1D.NetworkDataAccess
Assembly: DHI.Mike1D.NetworkDataAccess (in DHI.Mike1D.NetworkDataAccess.dll) Version: 19.0.0.0 (11.1.1.1111)
SyntaxThe ICatchmentConnection type exposes the following members.
Properties| Name | Description | |
|---|---|---|
 | Area |
Area of catchment that goes into this connection.
Use either Area or Fraction. Set Fraction to 0 to use Area.
|
| CatchmentId |
FlowType Id of catchment
|
| EndChainage |
End chainage of reach/branch
|
| FlowType |
Type of flow that this catchment connection handles
|
| Fraction |
Fraction of catchment discharge running into this connection.
Use either Area or Fraction. Set Fraction to 0 to use Area.
|
| IsOverlappingRiverArea |
Flag indicating if the catchment area is overlapping the river area,
and runoff is adjusted according to this.
It only has an effect for a connection span, not for connection nodes/locations. Default is false, M11/MH sets this to true. Should only be set to true for connections to open cross sections. |
| NodeId |
ID of node
|
| ReachId |
ID of reach/branch
|
| StartChainage |
Start chainage of reach/branch
|
Extension Methods| Name | Description | |
|---|---|---|
 | IsPointConnection |
Retruns true if the connection is a point connection
(Defined by NetworkExtensions.) |
See Also