InitialConditions Class

Initial conditions describes the values the state variables should initially have. The posibilities does not exclude one another but may well be used in combination. The possibilities are: Steady state solution State start Hot start Parameter First the values are set using a state condition, a hot start condition or a parameter condition, values are searched in that order. When done, the solver will do a steady state initialisation if UseSteadyStateSolution is activated.

A global value for the water level/depth and the discharge must always be set (default set to zero)

public class InitialConditions : IExtensibleDataObject

Public Class InitialConditions
	Implements IExtensibleDataObject

public ref class InitialConditions : IExtensibleDataObject