Tabulated Properties

Integer telling how the table should be interpreted When 0 then Q = f(Hups, Hdws) When 1 then Hups = f(Hdws, Q) When 2 then Hdws = f(Hups, Q)

Holds the header for the columns Type : Water level or discharge depending on the chosen calculation mode Unit: [m3/s] or [meter] Default: 0.0

Calculated Discharge derivative with DownStreamWaterLevel. Downstream is relative to the direction of chainage. The value is calculated by SetWaterLevels. Unit: [m^2/s]

Calculated Discharge derivative with UpStreamWaterLevel. Upstream is relative to the direction of chainage. The value is calculated by SetWaterLevels. Unit: [m^2/s]

Linear flow variation. For water level differences less than delhs use a linear Q variation between h1-h2=delhs and h1-h2=0. This is to avoid stability problems for small water level differences where dQdh goes to infinity. Unit: [m] Default: 0.01

Calculated Discharge. The value is calculated by SetWaterLevels. Unit: [m^3/s]

Factor that are multiplied with the discharge found from the table. Type: discharge Unit: [m3/s] Default: 1.0

Downstream water level.Downstream refers to the direction of chainage. The water level is set by use of SetWaterLevels Unit: [m]

Property used by (de)serializer, when it can not find proper target for a data field. Support of forward compatible data contracts.

Flow area through structure. Used by most (but not all) structures.

The discharge (and discharge derivatives) are scaled by the flow factor.

Structure ID

Used to get a consistent description of the structure. The ID comes in user units. Used e.g. when reporting errors, warnings and hints.

Flag to control if the structure is implicit or explicit. If the structure is explicit (Implicit == false) then the derivatives of the dicharge are always zero. Default value: true

Invert level down stream

Invert level up stream

Length of the structure. Unit: [m] Default value: 0m

Location property.

Number of columns in the table

Number of rows in the table

Holds the header for the rows Type : Water level Unit: [meter] Default: 0.0

The getter is used to get a list of errors.

Bank side that side-structure is located on

If side structure contains reservoir, and has the Coordinate set, this is not used (and should be set to Undefined).

Reservoir at end of side structure. Null if not side structure, or no reservoir is defined

Type of structure

Holds the table Type : Water level or discharge depending on the chosen calculation mode Unit: [m3/s] or [meter] Default: 0.0

String used to identified cross sections

Structure type, unique for each structure.

Upstream water level. Upstream refers to the direction of chainage. The water level is set by use of SetWaterLevels Unit: [m]

Datum to be applied to all water levels specified in the table. Type: water level Unit: [meter] Default: 0.0