StructureParameters Properties

Method to use when solving the culvert equations

Method to use when solving the culvert equations

In ILinearZeroVariation structures: For water level differences less than Delhs a linear Q variation is used between h1-h2=delhs and h1-h2=0. This is to avoid stability problems for small water level differences where dQdh goes to infinity. Unit: [m] Default: 0.01

Maximum iterations in composite structures to allow convergence of discharges when multiple structures are present in the same grid point. Default: 100

Maximum number of iterations in a structure to obtain convergence of the discharge. Default value = 100

Minimum head loss across a structure. Default value = 0.1

Flag specifying whether to use the global value Delhs for all structures or whether to have each structure seperately specify their own value, stored in Delhs.

If this is set, the Delhs will be overridden with the Delhs value.

Default is false.