RainBarrelTotalCollectingArea Property

Total collecting area is the area from which water is routed through the LIDS, either because rain is falling directly on the LIDs (Area) or when catchment rain (after losses) is routed to the LIDs.

This area is used by the catchment to figure out how much water should be routed to the LIDs, effectively splitting the catchment area in 3 parts:

Copy

catchment-No-LID-Area       = ICatchment.Area - sum(IStormwaterLID.TotalCollectingArea)
catchment-Route-To-LID-Area = sum(IStormwaterLID.TotalCollectingArea - IStormwaterLID.Area)
LID-area                    = sum(IStormwaterLID.Area)

The sum of all 3 contributions is the area of the catchment.

The TotalCollectingArea cannot be smaller than Area.

The sum of all TotalCollectingArea for all LIDs within a single catchment must be less than the area of the catchment they belong to.

Namespace: DHI.Mike1D.RainfallRunoffModule.LID
Assembly: DHI.Mike1D.RainfallRunoffModule (in DHI.Mike1D.RainfallRunoffModule.dll) Version: 19.0.0.0 (11.1.1.1111)

Syntax

C++

Copy

public double TotalCollectingArea { get; set; }

Public Property TotalCollectingArea As Double
	Get
	Set

public:
virtual property double TotalCollectingArea {
	double get () sealed;
	void set (double value) sealed;
}

Property Value

Type: Double

Implements

IStormwaterLIDTotalCollectingArea

Reference

RainBarrel Class

DHI.Mike1D.RainfallRunoffModule.LID Namespace

RainBarrelAddLanguageSpecificTextSet("LST887E9C6_0?cpp=::|nu=.");TotalCollectingArea Property

Property Value

Implements

Reference

RainBarrelTotalCollectingArea Property