Mike1DControllerRRCalibrate Methods

Change the state of the controller. Also triggers the ControllerEvent

Finish and clean up

Initialize the engine. Initialize sets up the engine net. When done, the EngineNet will be ready to inform on what data is available

Prepare the engine. This is called just before run is called.

Run the engine

Do RunUntil. Virtual method that must be overridden

Calling this function will end the simulation after the current timestep has been completed

Validate that the Controller does not have any errors/warnings

Determines whether the specified object is equal to the current object.

Allows an object to try to free resources and perform other cleanup operations before it is reclaimed by garbage collection.

Finish and clean up.

Serves as the default hash function.

Gets the Type of the current instance.

Initialize the engine. Initialize sets up the engine net. When done, the EngineNet will be ready to inform on what data is available

Initiate timings

Call to invoke a progress event

Returns true if the controller is in an active state and currently executing.

Creates a shallow copy of the current Object.

Prepare the engine. This is called just before run is called. I will set the initial state (initial conditions), open output files etc.

Put controller in a failed state, and issue a failed event on ControllerEvent

Trigger a custom special event

Run the engine

Must be called when running the engine manually, timestep by timestep, i.e. when not using the Run or RunUntil(DateTime) methods.

This is required for correctly transferring the engine to the run state before taking the time step.

Run the engine until endTime.

endTime should not exceed the simulation end time.

Calling this function will end the simulation after the current timestep has been completed

Returns a string that represents the current object.

Validate that the Controller/data access modules does not have any errors/warnings. Can be called before Initialize(IDiagnostics).