CouplingsUtil Methods |
The CouplingsUtil type exposes the following members.
Methods| Name | Description | |
|---|---|---|
  | DisableDispersion |
Disable dispersion for AD on the enode |
| FindNextQPoint |
Find next Q point. If the next Q point is on the other side of a junction node compared to chainage
the next reach Q point is being used.
|
| FindPreviousQPoint |
Find previous Q point. If the previous Q point is on the other side of a junction node compared to chainage
the previous reach Q point is being used.
|
| FindReachesWithLinkInside |
Find index of all reaches that are inside the link |
| FindSideStructureDirectionAngle | |
| GetAdjustedBoundaryValue(Double, Double, Double) |
Calculate an adjusted water level boundary value.
|
| GetAdjustedBoundaryValue(Double, Double, Double, Double) | |
| GetEngineNodeFromLocation | |
| IsOutflowReversed |
Figure out if the internal discharge direction in the HD module matches outflow.
Discharge is reversed, if the link is at the start of the reach. And the flag is flipped, if the ReverseDirection flag is set. Works for open boundary nodes only. |
| LastQPointDischargeGetter | |
| LimitArraysToSpan |
Linit arrays to min-max chainage span. This method is called when the chainage array goes beyond the chainage limits of the river reach.
|
| NorthAngleDegrees |
Angle to north in degrees
|
| SetWeirCrestLevel |
Set crest level of weir
|
See Also