Structure Fields |
The Structure type exposes the following members.
Fields| Name | Description | |
|---|---|---|
 | _accepts |
List of quantities that are accepted
|
| _controlStategyId |
If the structure is being controlled, then _controlStategyId contains the ID of the
active control strategy
|
| _downstreamWaterLevel |
Downstream water level, as set by SetWaterLevels(Double, Double)
Unit: [m]
|
| _dqdhDownstream |
The derivative of flow through the structure with downstream water level. The flow is
calculated in the derived classes when the SetWaterLevels method is called.
Unit: [m2/sec]
|
| _dqdhUpstream |
The derivative of flow through the structure with upstream water level. The flow is
calculated in the derived classes when the SetWaterLevels method is called.
Unit: [m2/sec]
|
| _flowArea |
Flow area through structure. Used by most (but not all) structures.
|
| _flowDir |
FlowDir is used to determine which parameters to use for the flow calculations.
Derived by the SetWaterLevels(Double, Double).
|
| _id |
Identification name of the structure
|
| _implicit |
If _implicit == false, then the derivatives are always zero.
Default value: true.
|
| _location |
Location in the network
|
| _offers |
List of quantities that are offered
|
| _q |
Flow through the structure. The flow is calculated in the derived classes when the
SetWaterLevels method is called.
Unit: [m3/sec]
|
| _runTimeDiagnostics |
Diagnostics are written into this Diagnostics during calculations.
Set during Initialize(IDiagnostics) |
| _topoID |
Identification used to find referenced cross sections
|
| _upstreamWaterLevel |
Upstream water level, as set by SetWaterLevels(Double, Double)
Unit: [m]
|
 | ZeroWaterLevelDifference |
The constant is used to define the lower limit for which we will try to calculate the flow and typically
more problematic the flow derivatives.
|
See Also