Also computes air volume (head space) from HD module water level.
public interface IAirHGridPoint : IFlowHGridPoint| CourantNumber |
The Courant Number reflects the fraction between the amount of volume flowing
through the cell in one time step and the amount of volume of water in the cell.
If the value is larger than one, all the water in the cell is "replaced" during a single time step. (Inherited from IFlowHGridPoint) |
| DischargeNph |
Discharge for time n+½
Unit: [m^3/s]
For internal grid points it is the average discharge between the upstream and downstream q grid point. For reach end grid points this is the time step average inflow/outflow to/from the reach (into/out off the grid point), used for mass balance. (Inherited from IFlowHGridPoint) |
| FlowAreaNpd |
Flow Area at time n+½ (crossSectional flow area)
(Inherited from IFlowHGridPoint) |
| FlowAreaNph |
Flow Area at time n+½ (crossSectional flow area)
(Inherited from IFlowHGridPoint) |
| GridPoint |
Engine grid point matching this gridpoint
(Inherited from IFlowHGridPoint) |
| SourcesOutflow |
Accumulated outflow sources (lateral outflow) at current time step. Always negative. It does not include SourcesOutflowSurface (Inherited from IFlowHGridPoint) |
| StorageWidthNph |
Storage width at time n+½
(Inherited from IFlowHGridPoint) |
| VolumeError |
Volume error in time step
(Inherited from IFlowHGridPoint) |
| VolumeN | Volume in grid point at time n (Inherited from IFlowHGridPoint) |
| VolumeNp1 | Volume in grid point at time n+1 (Inherited from IFlowHGridPoint) |